Promax HD Ranger + Manuel d'utilisateur télécharger pdf (Page 92)

March 2015 9-85

1111111111111111111

9.2

RF Connector

► DiSEqC commands:

The RF connector allows controlling an antenna using DiSEqC commands. DiSEqC

(Digital Satellite Equipment Control) is a communication protocol between the

satellite receiver and the installation accessories of satellite (switches, LNBs,

etc.) proposed by Eutelsat, in order to standardize the diversity of switching

protocols (13 to 18 V, 22 kHz) and meet the needs of the installations for the

reception of digital TV.

Connect the RF cable (see Figure 6) to the RF connector for the input

signal of the equipment.

Press the Spectrum key to access the spectrum analyser mode.

Press the Settings key and select the satellite band.

From the Settings menu, select the polarization (horizontal/vertical)

and the satellite band (high/low).

If necessary, enable the Supply output and select the supply voltage

for the LNB.

Select the option DiSEqC mode.

Two new functions appear on the softkeys: Command and Software

. DiSEqC programs appear classified in categories or folders.

Select the command or program and press the joystick to send it to

the antenna. These commands or programs allow the user to control

an antenna (for more information about DiSEqC commands and

programs see Annex 3

1 2 ... 87 88 89 90 91 92 93 94 95 96 97 ... 159 160

Pas de commentaire

Promax HD Ranger + Manuel d'utilisateur Page 92